BlogNews

1. Look for the freeway entrance sign. ...
2. Make sure that you are not entering the freeway exit ramp. ...
3. Follow the freeway entrance's speed limit. ...
4. Follow the freeway entrance's ramp meters signal lights. ...
5. Accelerate to a safe speed close to the flow of freeway traffic. ...
6. Merge into the freeway lane.

When entering a freeway you should speed up?

You have to be careful when entering the freeway. You should search ahead for traffic on the ramp as well as for a gap in traffic on the freeway. Using the acceleration lane, look for an opening in traffic, signal and accelerate to or near the traffic speed, yield to traffic already on freeway.

When entering a freeway you should not what?

If you want to enter the freeway but do not see a space for your vehicle in traffic, slow down on the ramp to wait for a gap. Do not drive to the end of the ramp and wait for a gap or you will not have enough room to accelerate to the speed of traffic before entering the roadway.

What are 3 safe driving strategies?

Following these defensive driving tips can help reduce your risk behind the wheel:

Why are expressways safer?

Designed for low risk higher speed travel. Despite high speeds and heavy traffic, you are safer on expressways than any other highways. Pedestrians, non-motorized vehicles and slow moving vehicles are not permitted. Wide Shoulders & extra wide underpasses for good escape paths.

How do you overcome Velocitation?

How To Overcome Velocitation. You can prevent velocitation by staying alert while driving; occasionally do a reality check by looking at your speedometer, and always practice safe driving. Drive only when you are mentally alert and well rested. Take a break to recalibrate when leaving the highway for a local road.

What is the rule to avoid tailgating?

Most rear-end collisions are caused by tailgating. To avoid tailgating, use the “Three-Second Rule.” When the vehicle ahead of you passes a certain point, such as a sign, count “one-thousand-one, one-thousand-two, one-thousand-three.” If you pass the same point before you finish counting, you are following too closely.

What does a special turnout area look like?

Special areas called turnouts are sometimes marked on two-way highways. You may pull to the side in these areas and allow cars behind you to pass. Some roads have passing lanes instead of turnouts to allow passing.

What are turnout areas used for?

Turnout Areas and Lanes

Drive into these areas to allow cars behind you to pass. Some two-lane roads have passing lanes. If you are driving slowly on a two-lane highway or road where passing is unsafe, and 5 or more vehicles are following, you must drive into the turnout areas or lanes to let the vehicles pass.

When must you dim your high beams?

If you are driving with your high-beam lights on, you must dim them at least 500 ft from any oncoming vehicle, so you don't blind the oncoming driver. You must use low-beam lights if you are within 200-300 ft of the vehicle you are following.

When two vehicles meet on a steep road where neither can pass?

When 2 vehicles meet on a steep road where neither vehicle can pass, the vehicle facing downhill must yield the right-of-way by backing up until the vehicle going uphill can pass. The vehicle facing downhill has the greater amount of control when backing up the hill.

Can you cross two sets of double yellow lines?

YOU CANNOT cross a double yellow line to pass another vehicle. Two sets of solid double yellow lines that are two or more feet apart sometimes appear as a road marking. ... Don't drive on or over these road markings. You may not make a left turn or U-turn across it.

When driving down a mountain road you should never?

Don't go down a mountain road any faster than you can go up it. Don't use your brakes to hold your downhill speed. Down shift to S or L – the only time you should step on your brake pedal is to slow while you are shifting down to a lower gear. Resist the temptation of zooming down a hill.

Which type of street has the highest number of hazards per mile?

City streets have the highest number of hazards per mile. Heavier in cities and city hazards can quickly block your path of travel.

What colors are the wrong way and do not enter signs?

The WRONG WAY sign may accompany the DO NOT ENTER sign. This rectangular red and white sign is a traffic regulatory sign. If you see one or both of these signs, drive to the side and stop; you are going against traffic. When safe, back out or turn around and go back to the road you were on.

Who most often falls asleep while driving?

Who's more likely to drive drowsy? Drivers who do not get enough sleep. Commercial drivers who operate vehicles such as tow trucks, tractor trailers, and buses. Shift workers (who work the night shift or long shifts).

What is the 3 to 4 second rule in driving?

What's good about the "3 second rule" is that it helps you keep a safe following-distance at any speed. Using the "3 second rule" gives you a bigger following-distance the faster you drive. Generally speaking, you should allow more than a 3 second following-distance in rain, fog and on icy roads.

What's the most difficult part of expressway driving?

Passing is one of the most dangerous maneuvers a driver can attempt. High speed passing on expressways adds to the danger and a high volume of traffic on expressways increases the chances of collisions. This being said, it is still safer to pass on an expressway than a two-lane roadway.

What is the 3/6 second rule?

The 3-6 second rule ensures the proper "space cushion" to keep you and other drivers safe. When driving on slippery roads, you should double your following distance to at least... 4 seconds. Stay to the right and only use the left lane for passing.